Now, we can attach the supporting legs that will sit flush to the two boxes. These should sit about 1/2″ off of the ground. These do not need to be glued and can be removed after the structure is complete, but I just leave mine on. These strips are used to screw the purple supports into so that you don't need to fuss with pocket holes. Next, we attach the green screw strips to the bottom base. I also pre-drill and counter-sink all of my screw holes and go back later to fill them with wood filler.įirst, we construct the two boxes which are the top and bottom faces. With this particular stand design, the weight of the tank transfers directly down the supporting legs and onto the base so that there is no sheering tension on any joints. The glue is what gives the structure long-term connection, the screws are to hold the wood in place while the glue dries. I will also need 3″ deck screws and wood glue. Since I want the top of my tank to sit at 51″ before a canopy or light, I must use (51 – 21) – 7 = 23″ 8x Blue = D – 3 = 18.5 – 3 = 15.5″ for the ends and cross-braces.4x Red = W = 49″ for the top and bottom rails.The board lengths that I need for this project are: I only use four colors for my stands and I also use additional cross-bracing. The actual dimensions of 2×4 boards are usually 3.5″ x 1.5″ with a thickness of. If you want to put a plywood top face on the stand, you will need to take into account the thickness of the plywood when you are determining the height of the stand. These plans will work for an aquarium with the same footprint as a 75g aquarium without any additional plywood. I have included the Sketchup plans at the bottom of this page. This is because acrylic will bow under the weight of the water if it is not supported across the entire area. With acrylic aquariums, full flat support is needed across the entire surface area of the bottom face of the tank. The key to glass aquariums is to have even, flat support on all of the edges, usually where the trim is on the tank. For this reason, we will define our Width (W), Depth (D) and Height (H) as 49″x 18.5″ x 21″. The inside dimensions of a 75g 48″ x 18″ x 21″ (WxDxH), but the actual outside dimensions of the aquarium are a little bit larger. We're going to work with a standard rectangular 75 gallon aquarium. The first thing we need to do is define the size of the tank you want to support. Here, I will walk you through how I build stands that will hold up to a standard 90 gallon aquarium. I built my stands with utility and simplicity in mind. It can be as intricate as your desire, or as basic as your needs. You can make your stand as tall or short as you want. Sometimes you find something you like, but you aren't sure it will support the weight of your tank Well, thanks to RocketEngineer over at Reef Central, there is an easy template for making your own stand that will stand the test of time. Every aquarium needs a stand and sometimes it's difficult or expensive to find a stand that suits you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |